FDMS
Clapet coupe-feu
FDMS – Clapet dans conduit de CVC qui empêche la propagation du feu et des produits de combustion d´un segment du feu à un autre segment en fermant le flux d’air aux points de fixation. Clapet est muni d´un collier, qui remplace la fonction des sceaux incendie et simplifie de sa propre installation dans les constructions, qui sépare le feu. Dans le cas de FDMS avec actionneur VAV, il est ajouter au clapet la fonction de contrôle de la vitesse de circulation d’air - comme un régulateur de débit d’air variable. Dans ce cas le boîtier du clapet est prolongé par une extension, qui inclut la croix de mesure et le contrôleur.
Propriétés
•Clapets de 100 à 630 mm
•Certification CE conformément à EN 15650
•Testé conformément à EN 1366-2
•Classifié conformément à EN 13501-3+A1
•Résistance au feu jusqu’à EI 90 S
•Étanchéité conformément à EN 1751 corps classe ATC 3, lame classe 2
•Résistance à la corrosion conformément à EN 15650
•FDMS Essai de cycles C 10 000 conformément à EN 15650
•FDMS avec actionneur VAV Essai de cycles Cmod conformément à EN 15650
•FDMS Mécanisme de commande mécanique ou par servomoteur
•FDMS avec actionneur VAV Mécanisme de commande par servomoteur et controller
•Vitesse d’air max.12 m/s, différence de pression 2500 Pa
•Certification "P-mark" de l'Institut RISE en Suède
Spécifications
Fire dampers are shutters in ducts of air-conditioning devices that prevent the spread of fire and combustion products from one fire segment to the other one by means of closing the duct in the points of fire separating constructions. In the case of FDMS the fire damper blade closes automatically air duct using a closing spring or a spring return actuator. In the case of FDMS with VAV actuator the fire damper has an additional function of the variable air flow controller. The return spring of the actuator is actuated when a thermoelectric activation device BAT (TAE - GRUNER) is activated, when a test button on BAT (TAE - GRUNER) is pressed or when power supply of the actuator is interrupted. In case of manual control with thermal fuse, the closing spring is actuated after the moment, when the thermal fuse is melted. After closing the blade, the damper is sealed with silicon against smoke penetration. On request by customer, the damper can be supplied silicon-free. In the closed position, the damper is also sealed with material which increases its volume due to increasing temperature and air proofs the air duct. The damper is equipped with an additional collar, in the position of the blade. On the collar, there are several metallic plates (fixtures for easy installation on the wall or ceiling construction).